A brief introduction to the laying procedure of insulating rubber sheet

There is no procedure for the necessity of laying insulating rubber sheets in the distribution room, however, according to some internal rules of the Electricity Industry Safety Operation Regulations (Electrical Part of Substation and Power Plant), many electrical operations require standing on insulating rubber sheets. For example, to handle high-voltage fuses (insurance), wear goggles and insulating gloves, apply insulating clips if necessary, and stand on an insulating rubber sheet or insulating table.

Adjustment of the rotating motor on the ? Cleaning brush and slip ring, should be performed by experienced electricians, and adhere to the following rules. When working on insulating rubber mats: (Insulating rubber boards are permanent fixed insulating mats) Do not touch the two poles or one pole and the grounded part together, nor work together.

When working on the rotor resistance circuit of a rotating motor, lift the carbon brushes or remove the resistor completely. Wear gloves or things with insulated handles, insulated boots or stand on an insulated board on the relay? When working on the second circuit operating on the instrument, it is necessary to be maintained by a person, use insulating things and stand on the insulating board.

High-voltage test personnel should pay attention to the whole process of pressurization, do not talk with others, always warn the anomalies, the operator should stand on the insulating mat, for convenience, people need to lay insulating rubber sheet frequently, and replace it with a long time when needed.